[Keyboard] Set USB max power consumption of kint* controllers to 100mA (#14546)

keyboards/kinesis/kint2pp/config.h

@@ -44,3 +44,7 @@
 // Reduce input latency by lowering the USB polling interval
 // from its 10ms default to the 1ms minimum that USB 1.x (Full Speed) allows:
 #define USB_POLLING_INTERVAL_MS 1
+
+// The Teensy 2++ consumes about 60 mA of current at its full speed of 16 MHz as
+// per https://www.pjrc.com/teensy/low_power.html
+#define USB_MAX_POWER_CONSUMPTION 100

keyboards/kinesis/kint36/config.h

@@ -63,6 +63,10 @@
 // from its 10ms default to the 1ms minimum that USB 1.x (Full Speed) allows:
 #define USB_POLLING_INTERVAL_MS 1
 
+// The Teensy 3.6 consumes about 80 mA of current at its full speed of 180 MHz:
+// https://forum.pjrc.com/threads/47256-What-is-the-power-consumption-of-the-Teensy-3-6
+#define USB_MAX_POWER_CONSUMPTION 100
+
 #define LED_PIN_ON_STATE 0
 #define LED_NUM_LOCK_PIN A14
 #define LED_CAPS_LOCK_PIN C7

keyboards/kinesis/kint41/config.h

@@ -90,6 +90,10 @@
 // from its 10ms default to the 125μs minimum that USB 2.x (High Speed) allows:
 #define USB_POLLING_INTERVAL_MS 1
 
+// The Teensy 4.1 consumes about 100 mA of current at its full speed of 600 MHz
+// as per https://www.pjrc.com/store/teensy41.html
+#define USB_MAX_POWER_CONSUMPTION 100
+
 /* We use the i.MX RT1060 high-speed GPIOs (GPIO6-9) which are connected to the
  * AHB bus (AHB_CLK_ROOT), which runs at the same speed as the ARM Core Clock,
  * i.e. 600 MHz. See MIMXRT1062, page 949, 12.1 Chip-specific GPIO information.